Steyr Club Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
See Fig. 10 below (Attached Thumbnails) copied from p.15 in the Steyr SSG 08 manual, under downloads at www.steyrarms.com

Trigger Adjustment

Screw 1 refers to the anterior most screw.
Screw 2 refers to the posterior most screw (along the mid curve of the trigger)


Adjusting of the trigger slack:

To reduce the trigger slack: turn the screw (1) in, anti clockwise
direction using a hex key wrench size 1.5.

To increase the trigger slack: turn the screw (1) out, clockwise
direction using a hex key wrench size 1.5.



Adjusting of the trigger slack resistance:

To reduce the trigger slack resistance : turn the screw (2)
out, clockwise direction using a hex key wrench size 2.5.

To increase the trigger slack resistance: turn the screw (2) in, anti
clockwise direction using a external star wrench T10.

Factory setting of the set trigger slack resistance:
400g/14,1oz +/-100g/3,52oz



Adjusting of the trigger pull:

To reduce the trigger pull: turn the screw (2) out, anti clockwise
direction using a hex key wrench size 2.5.

To increase the trigger
pull: turn the screw (2) in, clockwise direction using a external star
wrench T10. Factory setting of the set trigger pull: 1,6kg/3,52lb
+/-200g/7,0502oz
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top