Steyr Club Forums banner

1 - 10 of 10 Posts

·
Super Moderator
Joined
·
196 Posts
Discussion Starter · #1 ·
Found a SPP that look like it hasn’t been fired yet. Mags still wrapped and no marks anywhere. Guy was upgrading to a B&T I guess so I was happy to take it for1k since I haven’t seen one for less then 1500 for awhile. Anything I should know with it or Any advice on it? I plan to get the 1913 adapter and sbr it.
4340
 

·
Super Moderator
Joined
·
196 Posts
Discussion Starter · #3 ·
Shoot that is the new desk too so recent. Must have missed it, thank you.
 

·
Super Moderator
Joined
·
196 Posts
Discussion Starter · #5 ·
Any experience with this? I was looking to brace it and a 1913 rail would make that very easy
REHV ARMS 1913 REAR PICATINNY ADAPTER FOR STEYR SPP
 

·
Registered
Joined
·
740 Posts
That is one of the only ones that will work when I head that 1. there were none available I would buy 1 instantly if your getting it .
 

·
Super Moderator
Joined
·
196 Posts
Discussion Starter · #7 ·
That is one of the only ones that will work when I head that 1. there were none available I would buy 1 instantly if your getting it .
Thank you, I have one in order. I Just never heard of them Before, thank you
 

·
Super Moderator
Joined
·
196 Posts
Discussion Starter · #10 ·
Ran some 115-147 with it today and seemed to like the hotter ammo. Had two issues with 115 not feeding properly. Looked like a short stroke but it was at the end of the mag each time so sending this up to needing new springs and more mags to test.
 
1 - 10 of 10 Posts
Top