Steyr Club Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
6 Posts
Not sure what the proper names are.

1) make sure gun is unloaded

2) open cylinder

3) slide grip off about 1 inch

4) while looking from the muzzle turn ejector rod clockwise then take rod out be carefull not to loose the spring or pin

5) pull ejector out again be carefull not to loose the spring or pin

6) slide cylinder off theres a spring inside the yoke & a short sleeve inside the rear of the cylinder. reverse to reassemble

This is how i take apart my Raging Bull 454 the others might be a little different.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top