Steyr Club Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
235 Posts
Discussion Starter · #1 ·
I removed the rails/ trigger group from my M9-A1 to clean off factory grease and relube, I also removed the trigger (just the trigger nothing else) and after I put the gun together the trigger safety is always engaged (stays inside the trigger) D’OH! :oops:

how do I put the trigger back in properly? Where does the curved end of the spring (#20) go?

ps: I read the tutorial (after I took it apart) but it didin't really help :(
 

·
Registered
Joined
·
235 Posts
Discussion Starter · #4 ·
I got it...

btw I took it apart and tried to put it together before I looked for instructions here... I was doing it right latter but the spring was bent slightly from me trying to install it wrong. After I took a good look at the photos I reshaped the spring to what it was before so it works now.

thanks guys :)

it looks like the trigger spring will be the first thing to be (eventually) replaced on the gun, any places to get extras?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top