Steyr Club Forums banner
1 - 8 of 8 Posts
G

·
Discussion Starter · #1 ·
This was posted over at glocktalk.com and someone from CDNN susposibly stated there are only 2 Steyr's left. They come with 1 full capasity mag and 3 10 rds if I remember correctly from what was posted. I thought about it, but I don't have the money for them right now. These may be the last new Steyr M9's left in the country.
 

· Registered
Joined
·
1,190 Posts
Actually, this is very good news for us.
Steyr has no real incentive to support a discontinued handgun. Now they can concentrate on getting the MA1 into the marketplace. They have a vested intrest in supporting the newest products and getting the A1 placed into high profile LEO positions.

And to insure parts and service are available
 

· Registered
Joined
·
925 Posts
Nice,

Perhaps CDNN will buy a huge stock of A1s now to continue its success with selling Steyr pistols. I'd love to see CDNN sell A1s as they would most likely be a little less in price than other online dealers I've seen.

Furthermore, it would be awesome if all the parts were now A1 parts so that the plunger and other improvement could be enjoyed by M-series owners.
 

· Registered
Joined
·
1,190 Posts
ministerofdeath said:
Nice,

Perhaps CDNN will buy a huge stock of A1s now to continue its success with selling Steyr pistols. I'd love to see CDNN sell A1s as they would most likely be a little less in price than other online dealers I've seen.

Furthermore, it would be awesome if all the parts were now A1 parts so that the plunger and other improvement could be enjoyed by M-series owners.

Don't count on it, all the M's that CDNN purchased were at close out below cost, get rid of em prices. They might have purchased them at import level pricing.

Unlike most distributors, CDNN is a closeout house. The real Overstock.com .

This is not bad, just almost everything they sell is new old stock, or discontinued.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top