Steyr Club Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
909 Posts
Discussion Starter · #1 · (Edited)
Armorers Tips !!

To help you identify which barrel you have.

A Left-hand thread pattern or a Right Hand thread pattern.

A standard barrel is 13×1LH and has a larger Check Nut and only has a spot for the wrench .

USA barrel is 1/2×28 RH , The check-nut is half the size of the Standard. there is a groove cut along with the wrench flat, there is also a matching groove on the muzzle device.
If your barrel does not have a muzzle device the best way to tell is to look at the threaded end.

A USA barrel 1/2×28RH Has a groove cut at the end of the barrel behind the threads It also only has about half an inch of threads that are exposed
A standard barrel which is 13×1LH , has a shoulder of half an inch then it will have the exposed threads .
Camera accessory Cylinder Font Gas Auto part
Automotive tire Tire Bicycle part Cylinder Automotive wheel system
Font Office supplies Auto part Cylinder Writing instrument accessory
Office supplies Font Cylinder Wood Metal
Font Cylinder Liquid Wood Metal
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top