A good load for 9mm for you IPSC types

Discussion in 'Ammunition and Reloading' started by Rokchukrslave, Apr 12, 2007.

  1. Rokchukrslave

    Rokchukrslave New Member

    8
    0
    0
    This has been an excellent load for my M9A1:
    1. Brass of your choice. I have been using Federal once fired, shown here:
    https://www.edsbrassandreloaders.com/di ... tegoryId=4
    2. Zero 147gr. FMJ's, here: http://www.rozedist.com/
    3. Winchester sp primer. Cheap and available. I get these from OMC since they are local, for a little over $17 per 1000.
    4. 3.2 grains of Titegroup
    * Overall length of 1.125.
    This is an excellent, reliable, accurate low recoil load.
    I hope this helps somebody.
     
  2. bigtaco

    bigtaco Active Member

    1,791
    10
    38
    i WOULD go shoot ipsc, but until i get the guide rods out, i'm stuck in the shop all days of the week!!!

    good info. with the price of ammo and the amount of pracicing i like to do, i am forced to start reloading.

    when i get going, i'll run a batch of these and report back.